- The CHI Guard Home study shows that Oxidative Pollution travels along copper wires (including the electrical wiring in your home. It also demonstrates that, by absorbing Oxidative Pollution the CHI Guard Home reduces the principal complaints associated with EMF pollution and EHS.
Oxidative Pollution is collected by the electrical wiring system of homes. To study this phenomenon we needed to develop a research protocol to measure the flow of this Oxidative Pollution along copper wires. We unwound 30 feet of copper wire and asked several test subjects sensitive to the feeling of electrical buzzing of EMF to hold one end of the wire. This wire acted as an antenna, constantly collecting this ionizing or EMF or oxidative pollution from the atmosphere, so they felt a small buzz of agitation in their fingers just from touching the wire. When the other end of the wire was connected to a CHI Guard Home, the Oxidative Pollution was quickly drained from the wire. We asked the test subjects to indicate when they felt a change in the buzzing of the wire. They found that it took about 15 seconds to feel it. This means it took about 15 seconds for the condition of low Oxidative Pollution to flow from the CHI Guard to their fingers. This speed of propagation of irritating influences along a wire is consistent with the findings of the industrialist, Baron Carl von Reichenbach 200 years ago.
You can reproduce this experiment yourself. Stretch out any length of copper wire you like. We used 30 feet. Find a sensitive test subject to hold onto one end of the wire. Then connect the CHI Guard to the other end of the wire and time how many seconds pass before the test subject feels it. With several test subjects, you will probably find a propagation rate of 2 feet per second. This same phenomenon applies to your home electrical wiring. It is often the wiring, and not the WiFi or other electronic equipment which is the source for the buzzing, numbness, rash, or other signs of ionizing radiation.
High energy EMF in the frequency range of ionizing ultraviolet (Oxidative Pollution) is very hard to measure directly because it is immediately absorbed by our atmosphere and is delivered to the body by energized air molecules and not photons of ultraviolet light. However, the effects of this ionizing radiation are easy to measure. They are the symptoms often attributed to EMF sensitivity from cell phones, smart meters, and WiFi. The World Health Organization lists these as the most commonly experienced symptoms: “Dermatological symptoms (redness, tingling, and burning sensations) as well as neurasthenic and vegetative symptoms (fatigue, tiredness, concentration difficulties, dizziness, nausea, heart palpitation, and digestive disturbances).” WHO scientists have been unable to reproduce the claims that cell phones, WiFi, etc. can cause these symptoms.
CHI Institute has found several ways of quantifying the reduction of Oxidative Pollution. reduction with the CHI Guards and CHI Shield. All three products use the SludgeBuster technology to absorb and neutralize Oxidative Pollution, but absorb it from different places. These three tests also demonstrate the nature of Oxidative Pollution.
- The CHI Guard Auto connects to the steel body of the car, absorbing the high energy EMF produced by the car engine. By reducing the level of Oxidative Pollution in the air in the car, not only does it protect you and your family by reducing the high energy agitation of water molecules as demonstrated by the ejected salt.
- The study with the CHI Shield (pendant) shows that this technology truly does reduce the free radical load in the human body by measuring reduction in free radical end products in the urine.
- The CHI Guard Home study shows that oxidative pollution travels along copper wires (including the electrical wiring in your home. It also demonstrates that, by absorbing Oxidative Pollution the CHI Guard Home reduces the principal complaints associated with EMF pollution and EHS.